Maretron Alarm Module ALM100 Uživatelský manuál stáhnout pdf (Strana 248)

• User 1– This selection sets the vessel’s operating mode to “User 1”. All alerts

which are enabled in “User 1” mode will be enabled. All other alerts will be

disabled.

• User 2– This selection sets the vessel’s operating mode to “User 2”. All alerts

which are enabled in “User 2” mode will be enabled. All other alerts will be

disabled.

Changing the Operating Mode may disable a number of alerts. If any alerts are

Active or Awaiting Cancel they will remain Active or Awaiting Cancel until

acknowledged by the user, when they will be disabled if they are disabled in the

new operating mode. Alerts that have been Accepted (i.e. the condition causing

the alert is still present) will be disabled immediately if they are disabled in the

new operating mode.

Remote Alerts Play Computer Sound – When Alerts are received from another

N2KView or DSM250 Alert Source, the computer sound will beep while the Alert

is in the Active state if this box is checked

Only show alerts active in the chosen mode – If this is checked, then the

alerts shown in the Alerts Table will be limited to those active in the chosen

Operating Mode.

Alerts Table – This table lists all the alerts defined in this instance of N2KView.

Clicking on a row in the table will select an alert for editing or deletion. Double

clicking on a row in the table will open the Alert Edit Dialog for that alert.

The Annunc and Email columns give a quick overview of which alerts are

configured to send emails and sound annunciators in the current operating mode.

New – Click this button to create a new alert. A dialog will appear allowing you to

select a parameter and alert class, and the appropriate Alert Editor dialog will

appear, letting you configure the new alert.

Edit – Clicking this button causes the Alert Editor dialog to appear for the

selected alert.

Delete – Clicking this button causes the selected alert to be permanently deleted.

A warning dialog is displayed. Pressing the Delete button on the keyboard will

have the same effect.

Save – Clicking this button causes the new Alert Operating Mode to be Set and

then Alerts Setup Dialog to be closed.

Cancel – Clicking this button causes the Alerts Setup Dialog to be closed without

changing the Alert Operating Mode.

Revision 4.0.2 Page 248

1 2 ... 243 244 245 246 247 248 249 250 251 252 253 ... 379 380

Žádné komentáře

Maretron Alarm Module ALM100 Uživatelský manuál Strana 248