
Revision 1.3 Page 11
that the collar on the cable connector is tightened firmly. Connect the other end of the cable
(male) to the NMEA 2000
®
network in the same manner. The FFM100 is designed such that
you can plug or unplug it from an NMEA 2000
®
network while the power to the network is
connected or disconnected. Please follow recommended practices for installing NMEA 2000
®
network products.
Figure 7 – NMEA 2000
®
Connector Face Views
3 Configuring the FFM100
The FFM100 has several configurable parameters, which are shown below, including the
default values. If you are not using the default values, then you will need to configure the
FFM100 appropriately.
You can configure the FFM100 using a Maretron DSM150 display, DSM250 display, or
Maretron N2KAnalyzer software. For full details on the configuration procedure, please refer to
the User’s Manual for the product which you are using to configure the FFM100.
1. Advanced Configuration (Section 3.1)
a. Device Instance
b. Channel-0 Installation
c. Channel-1 Installation
d. Channel-0 Allow negative flow
e. Channel-1 Allow negative flow
f. Differential Mode Allow negative flow
g. Installation Description
h. NMEA 2000 PGN Enable/Disable
i. Restore Factory Defaults
2. Device Label (Section 3.2)
3. Operating Mode (Section 3.3)
4. Channel #0 (Section 3.4)
a. Channel Enable/Disable (Section 3.4.1)
b. Engine Instance (Section 3.4.2)
Komentáře k této Příručce