Maretron Run Indicator Module RIM100 Uživatelský manuál stáhnout pdf (Strana 7)

Revision 1.1 Page 3

®®

2.3 Mounting the RIM100

Attach the RIM100 securely to the vessel using the included stainless steel mounting screws

or other fasteners as shown in Figure 1 below. Do not use threadlocking compounds

containing methacrylate ester, such as Loctite Red (271), as they will cause stress cracking of

the plastic enclosure.

Figure 1 – Mounting the RIM100

2.4 Connecting the RIM100

The RIM100 requires two types of electrical connections: 1) the NMEA 2000

connection (refer

to Section 2.4.1), and 2) the monitored load connections, which are described in Section 2.4.2.

2.4.1 NMEA 2000

Connection

The NMEA 2000

connector can be found on the side of the enclosure. The NMEA 2000

connector is a round five pin male connector (see Figure 2). You connect the RIM100 to an

NMEA 2000

network using a Maretron NMEA 2000

cable (or compatible cable) by

connecting the female end of the cable to the RIM100 (note the key on the male connector and

keyway on the female connector). Be sure the cable is connected securely and that the collar

on the cable connector is tightened firmly. Connect the other end of the cable (male) to the

NMEA 2000

network in the same manner. The RIM100 is designed such that you can plug or

unplug it from an NMEA 2000

network while the power to the network is connected or

disconnected. Please follow recommended practices for installing NMEA 2000

network

products.

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Žádné komentáře

Modelos	Tipo de documento
GCD GCD-700	Manual de usuario Adcom GCD GCD-700 User's Manual, 16 paginas
S.A.F.E GFA-7707	Manual de usuario Adcom S.A.F.E GFA-7707 User's Manual, 14 paginas
GCA-510	Manual de usuario Adcom GCA-510 User's Manual, 8 paginas
GFA-4702	Manual de usuario Adcom GFA-4702 User's Manual, 24 paginas

Maretron Run Indicator Module RIM100 Uživatelský manuál Strana 7